12 postdoctoral-fluid-flow PhD positions at University of Southern Denmark in Denmark
-
by the POLIMA Center and its extensive network of international collaborators. POLIMA is a Center of Excellence funded by the Danish National Research Foundation (DNRF) for an initial period of 6 years
-
for next generation sequencing, single-cell transcriptomics, flow cytometry, mass spectrometry, metabolomics, bioimaging and transgenic mouse work. Strategic research alliances exist with Odense University
-
of Employment Employment as a PhD fellow is a 3-year salaried position and ends automatically at the conclusion of the period. The position holder may not undertake other paid work during this period. Employment
-
years. Employment stops automatically at the end of the period. The holder of the scholarship is not allowed to have other paid employment during the three-year period (the 5+3 programme ). Further
-
their MSc. Employment stops automatically at the end of the period. The holder of the scholarship is not allowed to have other paid employment during the three-year period The 4+4 programme : Appointment as a
-
. Application deadline: 20 June 2025 at 23:59 hours local Danish time Application, salary etc. Appointment as a PhD Research Fellow is for three years. Employment stops automatically at the end of the period. The
-
for SSM-SNN cores Integrate RISC-V processors using SoC flows Perform full-chip simulation, verification, and prototyping Publish and present research in high-impact venues Qualifications Applicants should
-
. Appointment as a PhD Research Fellow is for three years. Employment stops automatically at the end of the period.(the 5+3 programme ). Further information about the PhD programme at the Faculty of Science can
-
at 23:59 hours local Danish time Application, salary etc. Appointment as a PhD Research Fellow is for three years. Employment stops automatically at the end of the period. The holder of the scholarship is
-
-out key analog and mixed-signal building blocks (e.g., low-noise amplifiers, voltage/current sources, multiplexers, digital logic) for operation at cryogenic temperatures. Develop measurement setups